To connect your ZEUS+®, ZEUS® or VERUS® Edge to a Wi-Fi network / Internet, use the following instructions:
Connecting ZEUS+®, ZEUS®, or VERUS® Edge to Wi-Fi / Internet
Note: The Wi-Fi setup for VERUS® Edge will vary from the instructions shown as it uses Windows® 7, however they can be used as a general guide.
- Power on the scanner and allow Windows® to bootup, then allow the ShopStream® Diagnostic Suite software to open.
- Click the the Globe icon in the system tray to open the Wi-Fi connection panel:
- Wi-Fi Off / Disconnected
- Wi-Fi On (if grayed out Wi-Fi is On but disconnected)
- Turn on Wi-Fi:
- Windows® 11 - Click the Wi-Fi button to turn it on. Changes to blue color when on.
- Click the arrow to open the Network List
- Windows® 10 - Click the Wi-Fi button to turn it on. Changes to blue color when on.
- Choose your Wireless Network from the list, then select Connect. If needed, enter the network password.
- Windows® 11
Windows® 10
Video - ZEUS® Series How to Connect to Wi-Fi
Wi-Fi Status Indicators
Wi-Fi - Connected Successfully
Successful connection is indicated by this icon , where the number of bars displayed indicates signal strength.
If the connection is not successful, you may see an "X" or warning indicator on the icon.
Wi-Fi - Not Connected
This means there is no wireless link between your device and the router.
Things to check:
- Make sure your device Wi-Fi is turned on.
- Make sure you are NOT in Airplane Mode
- Check or Re-enter your network password
- Make sure you are within the signal range of the router, move the device as close as possible to the router to acquire a signal
Wi-Fi - Connected, but Not Connected to the Internet
Usually means the wireless link between your device and the router is working, but the router itself cannot reach the internet.
Things to check:
- Try and connect another device, to test your the connection
- Reboot your device
- Reboot the router
- Check your Internet Service Provider (ISP), make sure there isn't an outage and your account is active